Drizoro Products Required for Dincel Structural Wall Waterproofing:
Drizoro Maxseal Flex | Drizoro MaxMesh | Drizoro Maxjoint Elastic | Drizoro Maxplug| ARMA BLUE
Floor/wall joint:
Even surface:
Wet surface and apply Drizoro Maxseal Flex at the rate of 1mm thickness to the area covered by the Dincel Guide Track extending by 50mm past the area covered by the Track on to floor. Place Dincel Guide Track and secure as normal.
Uneven surface:
Wet surface and apply Drizoro Maxjoint Elastic to external edges of area covered by Dincel Guide Track at a thickness of no less than 6 mm x minimum width of 20 mm. Place Dincel Guide Track and secure.
Direct pour to Concrete Floor
Wet floor and apply Drizoro Maxseal Flex at the rate of 1mm thick to the area extending by 50mm past the area covered by the pour. After curing of concrete wet wall floor area at base.
Apply Drizoro Maxseal Flex at the rate of 1 Kg/m2 thick to an area from 100mm above floor/wall joint to 100 mm on the floor. Total 200mmm, place Drizoro MaxMesh (200mm x 50 mtr roll)
Allow to cure overnight, wet area and apply second coat at rate of 1 Kg/m2 covering the mesh.
Water penetration at floor/wall joint. – use Drizoro Maxplug to stop waterflow – precede as wall/floor joint recommendation
Return Wall Dincel Guide Track :
Wet surface and apply Drizoro Maxseal Flex at 1mm thickness approx. to Dincel Guide Track, fasten to wall as normal. Remove all excess using wet sponge. Total adhesion and waterproofing
After placing wall sections and filling with concrete:
Wet wall floor area at base.
Apply Drizoro Maxseal Flex at the rate of 1 Kg/m2 thick to an area from 50mm above Dincel Guide Track joint to floor.
Total 200mmm, place Drizoro MaxMesh (200mm x 50 mtr roll)
Allow to cure overnight, wet area and apply second coat at rate of 1 Kg/m2mm covering the mesh.
Vertical wall joints:
If required, seal all internal or external vertical joints if the structure is used for liquid containment or below ground retention. Mask if required.
Wet surface, apply Drizoro Maxseal Flex at the rate 1mm thickness over the joint area (min. 30mm) allow to cure overnight. Wet the surface, then apply a second coat at the rate of 1mm thickness.
Ensure that total floor area is coated using Drizoro Maxseal Flex at the rate of 1 kg/m2 Allow to cure overnight, wet area and apply second coat Drizoro Maxseal Flex at the rate of 1 kg/m2.
GENERAL:
To obtain superior adhesion on Dincel the areas to be coated can be abraded (wire brush, coarse sandpaper) just to take the shine off the surface.
WATER CONTAINMENT:
We recommend the application of Drizoro Maxseal Flex at the rate of 1kg/m2 per coat (2 coats) to the concrete slab. Can be applied immediately after placing the concrete (green) before installation of above.
Total Yield per 35 Kg Kit: 20m2 at 2 coats finish.
Finishing:
If finishing is required a single coat of Drizoro Maxseal Flex at the rate of 1 kg/m will provide a bonding bridge.
Anything that can be applied to a mortar surface can be applied to Drizoro Maxseal Flex.
Protection:
If Dincel needs to be protected prior to backfill, we recommend the use of ARMA BLUE PROTECT ALL or adhesive protection.
See brochure attached.
N.B: As each application has different requirements we offer a job specification and inspection service.
Hans Graf Director