0

CEMENTITIOUS FLEXIBLE KEYCOATING & JOINT WATERPROOFING

For DCT XPS GA 300 extruded polystyrene insulation boards

Specs 26

PRODUCTS REQUIRED

Choose one

Out of stock

Choose one

Out of stock

Out of stock

Choose one

JOINT DESIGN REQUIREMENTS

  • Minimum width/depth:
    • 5 mm for MAXJOINT ELASTIC
    • 10 mm for MAXJOINT ELASTIC EXPRESS
  • Maximum width/depth: 30mm

APPLICATION REMINDERS

  1. Apply MAXSEAL FLEX or MAXSEAL FLEX M in two coats and reinforce the junction with MAXMESH
  2. Thoroughly wet the surface before each application of DRIZORO product

JOINT TREATMENT DETAIL

METHOD

  1. Prepare area to be treated by removing any loose materials, previous coatings, or silicone mastic, ensuring a clean and sound surface.
  2. Joints between sheets greater than 3mm wide or deep must be filled with MAXJOINT ELASTIC or MAXJOINT ELASTIC EXPRESS in accordance with technical bulletins.
  3. Thoroughly wet the substrate, brush apply 1st coat of MAXSEAL FLEX or MAXSEAL FLEX M at 1 kg per m2.
  4. Embed MAXMESH, across all joints, into 1st coat, while still wet, lightly overcoat the MAXMESH with MAXSEAL FLEX or MAXSEAL FLEX M.
  5. Allow to cure for a min of 6 hours – MAXSEAL FLEX M or 16 hours – MAXSEAL FLEX.
  6. Thoroughly wet the substrate, brush apply 2nd coat of MAXSEAL FLEX or MAXSEAL FLEX M at 1 kg per m2.
  7. Leave for a min of 3 days – MAXSEAL FLEX M, 7 days - MAXSEAL FLEX prior to applying finishes.

IMPORTANT

All products must be used in accordance with the current Technical Bulletins and specific project requirements, including requirements relating to dimensions, surface preparation, mixing, and application.