Apply MAXSEAL FLEX or MAXSEAL FLEX M in two coats and reinforce the junctions with MAXMESH
Thoroughly wet the surface before each application of DRIZORO product
WATERPROOFING DETAIL
METHOD
Remove all loose, unsound or contaminated material ensuring a clean and sound surface. If Surface is previously painted all paint must be removed.
Confirm that the joints between the sheets, width is no less than 5mm wide for MAXJOINT ELASTIC or 10mm wide for MAXJOINT ELASTIC EXPRESS and does not exceed 30mm wide.
The joint depth must be at least half the joint width, with a minimum of 5mm deep for MAXJOINT ELASTIC or 10mm deep MAXJOINT ELASTIC EXPRESS and does not exceed 30mm deep.
Apply MAXJOINT ELASTIC firmly into the joint, ensuring complete filling and full contact with both sides.
Allow to cure for, MAXJOINT ELASTIC 7 days or MAXJOINT ELASTIC EXPRESS for 3 days.
Thoroughly wet the surface, brush on your 1st coat of MAXSEAL FLEX or MAXSEAL FLEX M at 1 kg per m².
While the first coat remains wet, embed the 200mm wide MAXMESH centrally over the junctions and lightly cover the mesh with MAXSEAL FLEX or MAXSEAL FLEX M.
Thoroughly wet the substrate, brush apply 2nd coat of MAXSEAL FLEX or MAXSEAL FLEX M at 1 kg per m².
Leave MAXSEAL FLEX for 7 days or MAXSEAL FLEX M for 3 days before applying a finish coat.
IMPORTANT
All products must be used in accordance with the current Technical Bulletins and specific project requirements, including requirements relating to dimensions, surface preparation, mixing, and application.
